![hp ilo 4 restart ilo interface hp ilo 4 restart ilo interface](https://4.bp.blogspot.com/_SquW7fpD118/TKvt3im24aI/AAAAAAAAAM8/yJghc5KamRQ/s1600/post64ilo3.jpg)
That will allow you to edit iLO IP without rebooting the server since the first message sounded like you had no iLO remote access due to the duplicate IPs. You can then edit and change the IP and then run: That will dump current config to that file. PS, open command prompt, switch to this folder and run this command:Ĭ:\Program Files\HP\hponcfg> hponcfg /w myilo.text and other private IP blocks, assuming you are using them, are free. Newer switches in some cases cannot support 100Mbps connections that older HP servers required for the iLO dedicated port, but iLO shared mode easily runs at 1Gb or even 10Gb depending on the server NIC.Īs for Garerth, IP addresses in the 10. Using less saves money and requires less cabling. So even if the server is crashed or has no OS, iLO in Shared mode continues to work.Īside from possibly flooding the port on the OS side, I am not aware of any losses in availability of the iLO when using this feature.Īs for why you would do this, the answer is simple economics, and for older severs, compatibility. NIC 1 in HP servers has a special hardware hook into the iLO. Though doing so requires your network admin to work some magic. The shared iLO function is a perfectly valid approach to wiring up your iLO.Īs has been stated, it needs it's own IP Address and depending on the iLO version that IP can be on a separate VLAN than the NIC/server is on. Scott, I would do some reading on the iLO Shared Network port function and how it works as some comments you're making in this thread are not entirely accurate. Never seen any disadvantage to this, other than possibly having multiple subnets already, but tacking a "1" to the beginning of the third octet (or dropping the 1, or replacing the 1 with a 2) can't be that hard.
![hp ilo 4 restart ilo interface hp ilo 4 restart ilo interface](https://i.ytimg.com/vi/tJN0mm0TQzM/maxresdefault.jpg)
Yeah, it's been quite some time since i made the transition from an HP shop to a Dell Shop, so i'm behind the times.īut either way, management ports (iLO or iDRAC) might as well be on their own subnet as a direct mirror of the physical server they are managing. I think on some of the entry level servers they still have a shared physical iLo/NIC port, but AFAIK that's just the hardware, the actual iLO is still configured/managed as if it were a dedicated look on the back of the server, you should see a network port marked "iLO" or "iLO 2", make sure that port is plugged in to a network switch. ILO should be running off it's own management port, not a standard network jack.